Good handling set-up requires precise toe adjustments, especially on race cars. This kit consists of 2 sets (right and left) of eccentric adjusters and slotted brackets which allow adjustment of the trailing arms. The brackets are welded to the out-board trailing arm pickup points of the subframe.

Best used in conjunction with the Ireland Engineering Adjustable Camber Kit

Also Available In Posi-Lock Style for Select Models(* below)
Our adjustable rear toe kit allows you to make toe adjustments for better handling and turn-in.The new, positive-lock type kit consists of two sets of brackets (left and right) and positive-lock type adjustment hardware. Each step (tooth) allows 1/16" of adjustment, and the total range is over 1.1". Another benefit is that only one wrench is required for adjustment (really helpful at the track). Kit fits 2002, E9/E12, E30 and E28/E24. Note: These plates are Zinc-plated, this plating should be ground off of the weld-zone prior to welding.

Tech Notes

• Removal of rear subframe, welding and some grinding is required.
• One kit does both sides.

This kit fits most BMW's with rear trailing arms including

• BMW 2002 - Posi-Lock Only
• BMW E30*
• BMW E30 M3
• BMW E9*
• BMW E12 - Posi-Lock Only
• BMW E24*
• BMW E28*
• BMW Z3
• BMW E36 318ti
• BMW E32
• BMW E34
• * denotes also available in Posi-Lock