When a BMW is lowered, the rear suspension gains camber. Often times, you end up with too much camber. This kit consists of 2 sets of eccentrics and machined slotted brackets. The brackets are welded to the inboard trailing arm pickup points, the eccentric hardware allows you to adjust camber.

Best used in conjunction with the Ireland Engineering Adjustable Rear Toe Kit

Also Available In Posi-Lock Style for Select Models(* below)
The new, positive-lock type kit consists of two sets of brackets (left and right) and positive-lock type adjustment hardware. Each step (tooth) allows 1/16" of adjustment, and the total range is over 1.1". Another benefit is that only one wrench is required for adjustment (really helpful at the track). Kit fits 2002, E9/E12, E30 and E28/E24. Note: These plates are Zinc-plated, this plating should be ground off of the weld-zone prior to welding.

Tech Notes

• Removal of rear subframe, welding and some grinding is required.
• One kit does both sides.

This kit fits most BMW's with rear trailing arms including

• BMW 2002 - Posi-Lock Only
• BMW E30*
• BMW E30 M3
• BMW E9*
• BMW E12 - Posi-Lock Only
• BMW E24*
• BMW E28*
• BMW Z3
• BMW E36 318ti
• BMW E32
• BMW E34
• * denotes also available in Posi-Lock